Z-Wave Garage Door Opener

$149.00 incl GST

The zConnect garage door opener is a Z-Wave controlled module and has two low voltage relay on board, two dry contact inputs, S-Bus port for external devices and sophisticated firmware to support multiple functions.

You can attach optional external devices to get audible and visual warnings to alert those nearby of the door’s impending movement, connect different binary and multilevel sensors via S-Bus port, IR beam sensor, limit switch to report its open or closed status to the Z-Wave Gateway etc. The zConnect garage door opener also works as a repeater for your Z-Wave network. If you are away from your home or property where you might want to remotely close garage, you can do it remotely from your smart phone or any internet enabled device via home automation application.

The zConnect garage door opener supports encrypted communications via the Security Command Class to prevent hacking and supports the Over the Air (OTA) feature for the product’s firmware upgrade (subject availability on your Z-Wave Gateway).

Please note: This device will work only with garage door motor which has dry contacts for the optional wall switch. Refer to your garage door motor manual. This device designed and assembled in Australia.

Available on backorder

Category: SKU: ZCO-WIN-GDC


The zConnect garage door opener pairs with your existing automatic garage door opener via wired garage motor wall opener momentary switch to provide wireless remote opening and closing control from your Z-Wave network and controller. When installed, you can open and close your garage door from anywhere. The zConnect garage door opener has a lot of build in extra functionality.


RF Protocol
Z-Wave  , SDK version: 6.51.03
RF Frequency
921.42Mhz ‐ AU/NZ  approved RF for Z‐wave
Indoor use only, for outdoor use watertight plastic box
4-24 VDC
Operation Range
Up to 45m indoors with no obstacles, 75
EN 60669-2-1
Operating Temp. -10C ~ +40C
18mm x 48mm x 37mm

Additional information

Dimensions18 × 48 × 37 mm